hi!
all the best in 2015 to all of you!
i am not quite getting the results i expect when i light up a wall - here you will find a pic of what i mean.
the emitter material is one pice round the corner - why dosent my wall get the same amount of light all over? i always have a hot-spot in the corners and not much light on the wall.
any idea?
thanks so much, patrick
a new Light Question
a new Light Question
- Attachments
-
- V3 Montana side 2 small.jpg (59.97 KiB) Viewed 10274 times
-
- under the light.jpg (29.14 KiB) Viewed 10274 times
Re: a new Light Question
That's because it's a one piece light bulb. What you should do is make 2 out of it by separating it at the corner then group each one. You should also uncheck "Low power".
Happy new year...
Happy new year...
Your support team.
https://SoftByteLabs.com
https://SoftByteLabs.com
Re: a new Light Question
thx!
ok, i will try this.
i dont find the box "low power" have you had a update?
thx, patrick
ok, i will try this.
i dont find the box "low power" have you had a update?
thx, patrick
Re: a new Light Question
Yes it is in the last update. You should always get the latest.
Your support team.
https://SoftByteLabs.com
https://SoftByteLabs.com