Raylectron Workflow
Posted: Sun Aug 23, 2015 5:29 am
Hi Raylectron Forum
I'm new here and to be honest, I have not yet installed Raylectron. Nevertheless, after a lot of searching and practical experience with different tools, I aim for Raylectron as the render tool of my choice.
Before I start, I want to ask two important questions to the forum which relate to the Raylectron-workflow. (certainly there are answers to my questions somewhere here, but I haven´t found them yet)
My first question
Which Render method uses Raylectron? Does Raylectron render infinitely long sample by sample and do I have to stop the render process when I reach my desired quality? - Or does Raylectron automatically stop the rendering process with any message like "finished rendering" or "Done" when the rendering is completed? (this last option would be most welcome to me)
My second question:
Since Raylectron is a stand-alone software: If I add or change any geometry within my SkUp model (a wall or a piece of furniture, etc), do I need to start editing in Raylectron completely from the beginning?
Thank you and I´m looking forward to your feedback
I'm new here and to be honest, I have not yet installed Raylectron. Nevertheless, after a lot of searching and practical experience with different tools, I aim for Raylectron as the render tool of my choice.
Before I start, I want to ask two important questions to the forum which relate to the Raylectron-workflow. (certainly there are answers to my questions somewhere here, but I haven´t found them yet)
My first question
Which Render method uses Raylectron? Does Raylectron render infinitely long sample by sample and do I have to stop the render process when I reach my desired quality? - Or does Raylectron automatically stop the rendering process with any message like "finished rendering" or "Done" when the rendering is completed? (this last option would be most welcome to me)
My second question:
Since Raylectron is a stand-alone software: If I add or change any geometry within my SkUp model (a wall or a piece of furniture, etc), do I need to start editing in Raylectron completely from the beginning?
Thank you and I´m looking forward to your feedback