Page 1 of 1

Metric/imperial fur grass issues

Posted: Sun Sep 03, 2017 5:07 am
by stevo1
HI, I was concerned that I could not understand how to use the fur/grass material after always getting totally weird results. I have done a bit of investigation. If you have a look at the attached screen shots you will see that the imperial default is OK but the Metric version default is how many blades per squre mm?! Hence how many blades into 1mmx1mm which is completely ridiculous. Can you please rectify this and change all metric defaults to the equivalent of the imperial default.
mm.jpg
mm.jpg (72.03 KiB) Viewed 2105 times
Inch.jpg
Inch.jpg (65.25 KiB) Viewed 2105 times

Re: Metric/imperial fur grass issues

Posted: Sun Sep 03, 2017 9:56 am
by Support
You should work in meters instead of mm, you can change it easily in the Raylectron Option menu. or if you use meters in Sketchup, it will send that to Raylectron, then you'll have blades per square meter instead in mm.