Metric/imperial fur grass issues

Raylectron ( is a 3D rendering engine for Trimble Sketchup (
Post Reply
Posts: 105
Joined: Sun May 20, 2012 4:28 am

Metric/imperial fur grass issues

Post by stevo1 »

HI, I was concerned that I could not understand how to use the fur/grass material after always getting totally weird results. I have done a bit of investigation. If you have a look at the attached screen shots you will see that the imperial default is OK but the Metric version default is how many blades per squre mm?! Hence how many blades into 1mmx1mm which is completely ridiculous. Can you please rectify this and change all metric defaults to the equivalent of the imperial default.
mm.jpg (72.03 KiB) Viewed 2642 times
Inch.jpg (65.25 KiB) Viewed 2642 times

User avatar
Site Admin
Posts: 1892
Joined: Sun Oct 02, 2011 10:49 am

Re: Metric/imperial fur grass issues

Post by Support »

You should work in meters instead of mm, you can change it easily in the Raylectron Option menu. or if you use meters in Sketchup, it will send that to Raylectron, then you'll have blades per square meter instead in mm.
Your support team.

Post Reply