Saving and reloading rof files & Rendering
Posted: Sun May 16, 2021 10:50 pm
I am brand new to Raylectron, and would like some guidance around saving and reopening files. Where I am a bit confuse around is saving either "save settings" or "save render" files doesn't output an rof file? When I open Raylectron and select the ryd option from within Raylectron doesn't seem to open it. I am assuming reopening the origional rof file should already include the updates from the ryd and the cfg saved files? Is this correct?
Can someone please confirm and can I please have some guidance how to save a complete data set so it retains all the settings and the renderings? And then how to open them where it includes everything from where I left off.
Also when it is Rending is seems to run indefinitely? Does it ever get to a point where it completes rendering and stops, or not? I assume the longer it runs the better the rending resolution becomes? However this doesn't seem to be obvious after its looking like the rending is pretty much complete.
Thanks for any advice and guidance.
Can someone please confirm and can I please have some guidance how to save a complete data set so it retains all the settings and the renderings? And then how to open them where it includes everything from where I left off.
Also when it is Rending is seems to run indefinitely? Does it ever get to a point where it completes rendering and stops, or not? I assume the longer it runs the better the rending resolution becomes? However this doesn't seem to be obvious after its looking like the rending is pretty much complete.
Thanks for any advice and guidance.