lack of light after update

Raylectron (https://Raylectron.com) is a 3D rendering engine for Trimble Sketchup (https://sketchup.com)
Post Reply
Thiago
Posts: 51
Joined: Wed Oct 18, 2023 6:54 pm

lack of light after update

Post by Thiago »

good morning

After updating the program it looked like this with the settings it used before

can anyone help
Attachments
Captura de tela 2024-03-08 140141.jpg
Captura de tela 2024-03-08 140141.jpg (166.65 KiB) Viewed 1345 times
Thiago
Posts: 51
Joined: Wed Oct 18, 2023 6:54 pm

files

Post by Thiago »

I'm cycling the light .001 by 100 to make it more or less as it was before

shushushshushus
Attachments
BANHEIRO-r4-Thiago.skp
(12.04 MiB) Downloaded 172 times
Captura de tela 2024-03-08 150837.jpg
Captura de tela 2024-03-08 150837.jpg (209.63 KiB) Viewed 1333 times
BANHEIRO-r1.rof
(58.62 MiB) Downloaded 140 times
BANHEIRO-r1.cfg
(22.99 KiB) Downloaded 149 times
User avatar
Support
Site Admin
Posts: 3183
Joined: Sun Oct 02, 2011 10:49 am

Re: lack of light after update

Post by Support »

Use Mode 1 instead of Mode 2 and for the portal, set the area adjustment to zero. For your light, set the area adjustment to zero and the power to 35, then, only set the area adjustment, not the power as this will make it more spot light.
Your support team.
https://SoftByteLabs.com
Thiago
Posts: 51
Joined: Wed Oct 18, 2023 6:54 pm

new settings

Post by Thiago »

hi, first thanks

follow the new settings,

OK??
Attachments
Portal.jpg
Portal.jpg (183.59 KiB) Viewed 1328 times
Illumination.jpg
Illumination.jpg (170.32 KiB) Viewed 1328 times
Emitter.jpg
Emitter.jpg (250.99 KiB) Viewed 1328 times
User avatar
Support
Site Admin
Posts: 3183
Joined: Sun Oct 02, 2011 10:49 am

Re: lack of light after update

Post by Support »

To make the room brighter, increase the Portal's Area Adjustment. But the sun is not shining inside the bathroom, if it did, it would be brighter.
Your support team.
https://SoftByteLabs.com
Thiago
Posts: 51
Joined: Wed Oct 18, 2023 6:54 pm

emitter 2 configuration

Post by Thiago »

This image is past 120
Attachments
Emitter-2 120 samples.jpg
Emitter-2 120 samples.jpg (205.43 KiB) Viewed 1323 times
User avatar
Support
Site Admin
Posts: 3183
Joined: Sun Oct 02, 2011 10:49 am

Re: lack of light after update

Post by Support »

It looks good, and you do not have to let it run for that long, you can stop the render when it looks good or when there are no more visible differences from one frame to the next. Maybe 20 is good enough.
Your support team.
https://SoftByteLabs.com
Post Reply