lack of light after update

[Thiago]

good morning

After updating the program it looked like this with the settings it used before

can anyone help

[Thiago]

I'm cycling the light .001 by 100 to make it more or less as it was before

shushushshushus

[Support]

Use Mode 1 instead of Mode 2 and for the portal, set the area adjustment to zero. For your light, set the area adjustment to zero and the power to 35, then, only set the area adjustment, not the power as this will make it more spot light.

[Thiago]

hi, first thanks

follow the new settings,

OK??

[Support]

To make the room brighter, increase the Portal's Area Adjustment. But the sun is not shining inside the bathroom, if it did, it would be brighter.

[Thiago]

This image is past 120

[Support]

It looks good, and you do not have to let it run for that long, you can stop the render when it looks good or when there are no more visible differences from one frame to the next. Maybe 20 is good enough.